wedopk.blogg.se - Acer predator x34 microcenter

I'm ordering 15mm spacers and longer M4 screws so I can mount this. Holes line up, but the opening on the monitor is 122x122mm and my bracket is 124x1124mm.

VESA supports 100x100 but the opening in the back is SLIGHTLY too small to fit my VESA arm bracket.

My only complaints so far are the following: My wireless mouse has a charging stand, so I plug the stand into this port so when my computer is off the mouse can still charge. You can also configure it to be an "always on" port. It Can supply 5v 1.5A for slightly faster device charging. One of the two USB ports on the side is considered a "charging port".

Audio interface for my Mic + Headphones.

Mouse (wireless mouse: the charging stand doubles as a dongle).

I have the following plugged into the USB hubs:

Laptop (MacBook Air during home use, Lenovo at work) with a single USB C 3.1 gen2 (DisplayPort, USB, and PD charging).

Gaming PC over DisplayPort & USB-B (for USB hub).

Both laptops have thunderbolt/USB-C capabilities so being able to dock/charge them with 1 cable to the monitor will be nice.

I also have a personal laptop: 2020 Macbook Air. My current setup at home is a Gaming computer and a Lenovo T14s for Work. I put an order in the other day at MicroCenter, so I'll see how it works. The extra ports are nice for more than just mouse + keyboad. One downside is 2 of those USB ports are on the side of the monitor instead of the back I/O. However the official "Quick Start Guide" for this monitor shows it has USB-B Upstream, along with 4xUSB-A 3.1 ports.

Even Acer's own product page only mentions 4xUSB, no upstream. The real X34 GS is supposed to have it, so I think there may be an issue with Micro Center's I think that might just be error on behalf of specs that MicroCenter/Acer give.

It lacks upstream USB-B (crucial for a PC connection). However the listing I found at Micro Center does not appear to be the X34 GS.

I assume you're talking about the Acer Predator X34 GS.